Advertisement
3
Installing the Leak Detector
Tank
No Parts Required
Procedure
1.
For machines with a carbon canister
attached to the leak detector tank:
A.
Install the canister bracket
tank with the 2 mounting screws.
B.
Slide the carbon canister into the canister
bracket beneath the leak detector tank.
2.
Lubricate and place a new O-ring on the straight
barb fitting removed in step 8.
3.
Install the straight barb fitting into the underside
of the kit leak detector tank; tighten it to 23 to
28 N·m (17 to 21 ft-lb).
4.
Connect the valve hose to the straight barb
fitting and secure it with a hose clamp.
5.
Connect the overflow hose to the
leak-detector-tank barb and secure it
with a hose clamp.
6.
Apply anti-seize lubricant to the end threads of
the 4 cap screws that are used to secure the
leak detector tank to the hydraulic tank.
Important:
Do not overtighten the cap
screws when you secure the leak detector
tank to the hydraulic tank. The threads in the
tank may become damaged.
7.
Secure the leak detector tank to the hydraulic
tank with 4 cap screws, spacers, neoprene
washers, and flat washers.
8.
Torque the cap screws to 3 to 6 N∙m (30 to 50
in-lb).
9.
Trim the dipstick to the marked trim line at 9.5 cm
(3-3/4 inches) as shown in
the dipstick into the leak-detector-tank opening.
(Figure
2) to the
Figure
4, then install
4
1. 9.5 cm (3-3/4 inches)
4
Completing the Installation
No Parts Required
Procedure
1.
Fill the hydraulic tank with the drained hydraulic
fluid; refer to your machine Operator's Manual.
2.
Ensure that the leak detector system is
operating; refer to your machine Operator's
Manual
3.
Connect the battery; refer to your machine
Operator's Manual.
Figure 4
2. Trim the dipstick here.
g224251
Advertisement
