Gearshift Lever - BMW Motorrad R 18 2021 Rider's Manual

76 ADJUSTMENT
Basic setting of the rear
spring preload
Turn hexagon head as far as
it will go counter-clockwise.
(filled up, with driver's weight
of approx. 85 kg)
Turn hexagon head as far as
it will go counter-clockwise,
then 6 turns in clockwise dir-
ection. (One-up with load of
approx. 110 kg)
Turn hexagon head as far as
it will go counter-clockwise,
then 24 turns in clockwise
direction. (Two-up with load
of approx. 200 kg)
If the load differs from the
base settings, increase spring
preload 2 full turns for every
10 kg of extra weight.
Install the side trim panel
( 111).

GEARSHIFT LEVER

Adjusting gearshift lever
ATTENTION
Unintentional operation of
the gearshift lever
Damage to the gearbox
Check that the gearshift
lever is in the correct pos-
ition.
Make sure that the gearshift
lever is under no load ex-
cept when gearshifting is in
progress.
Remove screw 2.
Disengage gearshift lever 1
from gearshift shaft 3.
Hold gearshift lever 1 in the
desired position relative to
the gearshift shaft and push it
on to gearshift shaft 3.
Install screw 2.
Gearshift lever to se-
lector shaft
M6 x 25