Batteries And Charging - Action NT Series Owner's Manual

 Battery charge will last up to six hours, depending on battery condition, temperatures and
type of use the Trackchair is subject to (terrain and weight of rider). The Trackchair has a
built-in battery charger that plugs into 240 volts using the power cord provided.
Operation after Applying AC Power to a ProSport Charger Connected to
Discharged Batteries
During the startup test the battery type LED will be illuminated and the red charge mode LED will flash indicating that the
unit is in a self-test mode. When complete and if there are no faults, the charger's system check OK indicator will illuminate
green and the ProSport's solid red charging LED will be ON indicating the charge process is initiated. Note: If there is a fault
the appropriate bank LED will illuminate and the charge process may not start, depending on the location of the fault.
If there are no Battery Faults, the Green System Check OK LED will illuminate and the following sequences will
proceed:
The red battery type LED (factory set for standard Flooded (lead-acid)/AGM batteries) will illuminate.
The red charge mode LED will illuminate indicating the charger has started its multi-stage charging process.
When the charge process is approximately 80% complete the red charge mode indicator will turn off and the amber
conditioning LED will turn on indicating the conditioning mode.
When the multi-stage charge process is completed you will observe the following: Battery type red LED goes OFF.
The red charging LED and the amber conditioning LED will be off and the green ready/maintain LED will illuminate indicating
your batteries are fully charged.
The only LEDs on after the multi-stage charge process is completed are the green system OK LED, blue AC power LED and
the green ready/maintain LED.
Multi-Stage Charging Overview
Stage 1 - System Check OK and Battery Analyzing: During this stage the ProSport red "Charge" LED will
flash indicating ProSport is analyzing all battery connections in addition to checking each battery is capable of being
charged. Upon completion the "System Check OK" indicator will illuminate green followed by Stage 2 Charging.
Stage 2 - Charging: During this mode the "Charging" indicator will be red. The ProSport Series will use all of
its available charging amps (as controlled by temperature) until the battery voltage is raised to 14.6VDC
(Flooded lead-acid factory setting).
Stage 3 - Conditioning: During this mode the "Conditioning" status indicator will be amber. Batteries will hold
at 14.6 VDC (factory set for Flooded lead-acid batteries) to complete charging while conditioning each battery
connected. Upon completion the ProSport will go into its Energy Saver Mode.
Stage 4 - Auto Maintain (Energy Saver Mode): During this mode the blue "Power" and green "Auto Maintain"
LED's will be on indicating Stage 2 charging and Stage 3 conditioning are completed. At this time ProSport will
initiate its Auto Maintain (Energy Saver Mode) which will monitor and Auto Maintain batteries only when needed
to maintain a full state of charge.
Stage 5 - Storage Recondition Mode: During this mode the ProSport "Storage Recondition Mode" green
indicator will illuminate with a slow fade in and out pulse. This indicates that while your batteries/boat are in storage
the ProSport will automatically recondition all batteries for up to 3 hours once a month extending battery life
and maximizing on the water battery power performance.
Revised September 27, 2016

Batteries and Charging

Page | 7