Australian Standards Requirements; Power And Control System Circuitry - Action NT Series Owner's Manual

Australian Standards Requirements:

The KCF Disability Engineering Action Trackchair has been tested to the following Australian Standards methods:
AS3696-1:2008, AS3696-2:2008, AS3696-3:2008, AS3696-4:1992, AS3696-5:1989, AS3696-6:1990, AS3696-8:1998,
AS3696-9:2008, AS3696-10:1990, AS3696-14:1998, ISO7176-7:1996 and with the relevant requirements of
AS3695.2:2013 (excluding the methods indicated in the report as "not tested" or "not applicable")
1. This is a Class C wheelchair which is not intended for indoor use but capable of travelling over longer distances
and negotiating outdoor obstacles.
2. Caution should be exercised when negotiating steep slopes as the capabilities of the Action Trackchair may
exceed the capabilities of the operators to safely negotiate these obstacles.
3. The identification plate is attached to the steel seat frame on the left hand side.
4. The action of disengaging the drive motor levers will put the Action Trackchair into a freewheel mode and as
such there is no braking on the Action Trackchair.
5. Surface temperatures can increase when the Action Trackchair is exposed to external sources of heat (e.g.
sunlight).
6. Dispose of used batteries at a registered waste handling facility.
7. As of the printing date of this manual the flammability testing of the seating components has not yet been
completed.
8. Please refer to page 15 and 16 for information on the power and control system circuitry.
9. The Action Trackchair could disturb the operation of other devices in its environment if these devices are
susceptible to electromagnetic interference.
10. The driving performance of the Action Trackchair could be influenced by electromagnetic fields that are
generated by other devices.
11. The manufacturer, Australian importer, SWL, year of production and serial number are printed on an adhesive
label attached to the steel frame on the right hand side of the seat base.
12. An "AS/NZS 3696.19 non-compliant adhesive warning label" is attached to the steel frame stating that the
Action Trackchair is not intended for use as a seat in a motor vehicle.
Revised ~ April 15, 2016
15