Table of Contents
Advertisement
SWITCH SETTINGS
Set these switches before using the TC-520.
TONE/PULSE
This switch (located on the back of the base
unit) tells the TC-520 to dial out with either
touchtone or pulse signals to match the service
you have with your local telephone company.
The TC-520 is shipped with the
PULSE SWITCH
in the Pulse position. If you
have touchtone service, set this switch to tone.
PULSE = for Rotary dialing or Pulse systems
TONE = for Touchtone systems
POWER SAVER/
RINGER ON-OFF
The TC-520 is shipped with the
RINGER SWITCH
handset) set to "off". When the ringer is "off", the
POWER SAVER
is "on" and battery power is
conserved. Turn the handset ringer on before use.
RINGER ON - When the ringer is ON, the
handset will ring when an incoming call or
paging signal is received. The rechargeable
batteries will last up to seven days in this mode
(the Power Saver Switch is OFF.)
POWER SAVER (PWR SAVER) ON - When
an incoming call is received the handset will not
ring, but all other handset functions will operate.
The rechargeable batteries will last up to 2
months in this mode (the ringer is OFF.)
BASE RINGER ON-OFF
The TC-520 is shipped with the base unit ringer
"ON". To turn the ringer ON or OFF:
1
TIME
Press and hold
beep.
TONE/
HANDSET
(located on the side of the
until you hear a
ON/OFF
2
Press
A "beep" indicates the base unit ringer is
OFF. A "ring" indicates the ringer is ON.
3
TIME
Press
when finished.
PROGRAMMABLE
RING SELECT
The TC-520 is preset to answer on the 4th ring.
The unit may be programmed to answer on the
second or fourth ring, or to answer using the
Tollsaver (2-4) setting. When calling to check for
messages, tollsaver will help eliminate toll charges
by letting you know if there are any new
messages before the TC-520 answers. If there
are no new messages, you can hang up before
the fourth ring to avoid unnecessary toll charges.
1
TIME
Press and hold
until you hear a beep.
2
F FWD
Press
within 10 seconds of
TIME
pressing
. Each time you press
F FWD
a synthesized voice will
announce the new setting.
When you hear:
2
= The TC-520 will answer on the second ring.
2-4
(Tollsaver) = The TC-520 will answer calls
in the tollsaver mode:
Second ring = new messages
Fourth ring = no new messages
4
= The TC-520 will answer on the fourth ring.
3
TIME
Press
after the desired setting is
announced. You will hear two beeps.
The TC-520 will now answer calls using
the programmed setting.
GENERAL
PAGE
9 9 9 9 9
(under the cassette lid).
(about 2 seconds)
Advertisement
Table of Contents
