Unimotion MSD MG Assembly Instructions Manual
  1. Manuals
  2. Brands
  3. Unimotion Manuals
  4. DC Drives
  5. MSD MG
  6. Assembly instructions manual

Unimotion MSD MG Assembly Instructions Manual

Motor side drive with a timing belt
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

ASSEMBLY INSTRUCTIONS
MSD MG
MOTOR SIDE DRIVE
WITH A TIMING BELT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MSD MG and is the answer not in the manual?

Questions and answers

Related Manuals for Unimotion MSD MG

Summary of Contents for Unimotion MSD MG

  • Page 1 ASSEMBLY INSTRUCTIONS MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT...

  • Page 2: General Information

    ASSEMBLY INSTRUCTIONS / MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT GENERAL INFORMATION GENERAL INFORMATION In this assembly instructions the linear unit and electric cylinder or slider, on which the motor side drive MSD will be mounted, are designated as product. The motor or the gearbox are designated as motor. There is also an abbreviation MSD used, by which the motor side drive is defined.

  • Page 3: Identification Label

    ASSEMBLY INSTRUCTIONS / MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT GENERAL INFORMATION / PARTS LIST IDENTIFICATION LABEL 1 – ID number 2 – Manufacturing date of the motor side drive 3 – Type of the motor side drive (ordering code...
  • Page 4 ASSEMBLY INSTRUCTIONS / MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT MOUNTING MOUNTING Requirements for personnel Avoid from collision of the moving components and the motor side drive (or the motor). The motor side drive may only be mounted by appropriately There must never be any collision of the mounted qualified personnel.
  • Page 5 ASSEMBLY INSTRUCTIONS / MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT MOUNTING STEP 4: Place the motor belt pulley 10 on the motor shaft. L [mm] VK MG Type Ensure that the motor belt pulley 10 and the motor (±0,2 mm)
  • Page 6 ASSEMBLY INSTRUCTIONS / MSD MG MOTOR SIDE DRIVE WITH A TIMING BELT MOUNTING STEP 6 AND 7 STEP 6: Push the motor in the direction of the product to shorten the centre-to-centre distance between both of the belt pulleys 3 and 10.

  • Page 7: Initial Start-Up

    Dismounting the motor side drive To dismount the motor side drive MSD MG, take precautions, such as turning off the power supply and prevent the moving components of the product from dropping, if it is in a vertical or inclined position. It should be also noted, that during the operating process hot surfaces of the motor, motor side drive MSD and product may occur.

Table of Contents