Advertisement
Pairing
1.
Turn on the drone. The LEDs flash.
2.
Place the drone on level ground.
3.
Turn on the remote control. The remote control's LED flashes.
4.
Move the throttle all the way up and then down to
pair the remote control with the drone. The drone's
blades remain still during pairing. When paired, the
LEDs on both the remote control and drone light
steadily.
Note: If pairing fails, turn off the drone and remote control
and repeat the steps above, or change locations to avoid
electrical interference.
Fly
1.
After pairing, push the steering control in to switch
between advanced mode to fly in high speed
(double beep) and beginner mode to fly in low speed
(single beep).
2.
With the drone on the ground, move the throttle
forward to ascend. To avoid ground air turbulence,
fly the drone at least 1 ft. (30cm) off the ground.
IMPORTANT: If your drone crashes upside down, pull
the throttle down and switch off the remote control first.
Never touch the drone when propellers are still moving.
Trim
Move the throttle forward and see how the drone reacts.
Forward/Reverse Movement If the
drone tends to move forward, press
6
; if it tends to move backward,
5
press
.
Note: The remote control beeps when you press a trim control but stops
beeping when you reach maximum trim adjustment.
Left/Right Slide Trim:
If the drone tends to slide right, press
5
; if it tends to slide left, press
13
6
.
Advertisement
