Pcb Photo And Address Code Setting - Haier CA0035EAND Service Manual

10. PCB Photo and Address Code Setting

Address Code Setting(SW0401-1~4)
The former four digits of the eight-digit code switch are for module address setting, and the latter four for unit mode
and capacity setting. The unit mode and capacity codes have been set in delivery, and they are unchangeable. The
unit address codes default to ON, ON, ON and ON (for master unit), and in delivery, the codes default to ON, ON, ON
and ON.
Dip1 Dip2 Dip3
ON ON ON
ON ON ON
ON ON OFF
ON ON OFF
ON OFF ON
ON OFF ON
ON OFF OFF
ON OFF OFF
OFF ON ON
OFF ON ON
OFF ON OFF
OFF ON OFF
OFF OFF ON
OFF OFF ON
OFF OFF OFF
OFF OFF OFF
---- ---- ----
---- ---- ----
---- ---- ----
---- ---- ----
---- ---- ----
---- ---- ----
---- ---- ----
---- ---- ----
Note:
(1) There is no same address code in one system.
(2) The above address codes must be set by professionals.
Dip4 Dip5 Dip6 Dip7
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
ON ---- ---- ----
OFF ---- ---- ----
---- ON --- ---
---- OFF --- ---
---- --- ON OFF
---- --- OFF OFF
---- --- OFF ON
---- --- ON ON
----
----
Dip8 Description
---- Module address:0
---- Module address:1
---- Module address:2
---- Module address:3
---- Module address:4
---- Module address:5
---- Module address:6
---- Module address:7
---- Module address:8
---- Module address:9
---- Module address:10
---- Module address:11
---- Module address:12
---- Module address:13
---- Module address:14
---- Module address:15
--- Cooling only
--- Heat pump
--- CA0030CAND
--- CA0070CAND
--- CA0100CAND
--- CA0130CAND
ON R22
OFF R410A
43