OPCOM Grow Wall3 Manual

D. Optional Accessories
1. Black Cloth Cover 2. Anti Insect Net
E. Maintenance
F1. Add Water
1. Measure the pH/EC value every 1-2 weeks and add water to maintain the vlaue balance
F2. Change Water
1. After a cycle of planting, change the water and clean the unit.
2.When changing water, clean water gateway on each planting layers, you may also add moss
detergent in the water tank to avoid the moss remaining
3. On the regular basis of every 1-2 weeks, clean the filtering sponge in the pump
F3. EC Meter Use and Calibration
1. Keep the electrode clean of EC meter and cover the electrode protective cap when not in use.
2. Turn off the meter when not in use for an extended amount of time.
F. Troubleshooting
Issue Checkpoints / Solution
Make sure all power cables are connected.
Lamps not Power button is ON.
lighting up Make sure LED status is ON
If it is on HI or LOW mode, the lamp has off time, during 24-hour cycle.
Pump has a Pump may make a buzzing sound in the beginning due to air inside the pump. After a minute with
buzzing sound water running through the pump, this sould be reduced.
The lamp/ pump Control Box is designed with Auto, HI and LOW modes, which turn the lamps and the pump on and off
stop Safter hours periodically. It simulates an outdoor daily cycle to offer the best growing condition
Rotate the ring at the end of the pump clockwise or counterclockwise to get the most suitable water flow
Make sure it is not clogged at the water flowing gateway on each planting layer
Water Over flows
G. Installation steps of water pump
1. As shown in the picture: 2. Insert the upper water pipe
prepare the backup pump. into the water tank inlet
F1708038 P17092804
F1709051
For more information, please visit
www.opcomfarm.com
3. 500W Water Auto Heater
(fig 1 )
4. Plug in DC jack
3. Connecting control valve
PATENT
CM
C US
Intertek
P17103002 4010499
(Fig1)
5. Pump replacement is
completed as shown in the tank
Ver.: 202006
Grow Wall3
Hydroponics Grow Wall 3
Manual