OPCOM GrowTank OFG005 Manual

E1.Add Water
1.Measure the pH/EC value every 1-2 weeks and add water to achieve the value balance.
E2.Change Water
1.After a cycle of planting, you may want to change water or clean the unit (fig1)
2.When changing water, clean water gateway on each planting layers, you may also add moss detergent in
the water tank to avoid the moss remaining.
3.On the regular basis of every 1-2 weeks, clean the filtering sponge in the pump.
E3.EC meter Use and Calibration
1.keep the electrode of EC meter clean and cover the eletrode protective cap when not in use.
2.Remove batteries when the EC/pH meter is not used for a long period of time.
Issue Checkpoints / Solution
Make sure all power cables are connected.
Lamps not
Make sure Power button is ON.
Iighting up
Make sure LED status is ON.
If LED Status is on HI or LOW mode, there is an off time setting for lamp during 24- hour cycle.
Pump may make a buzzing sound in the beginning due to air inside the pump. After a minute with water
Pump has a
buzzing sound running through the pump, this sould be reduced.
The lamp/ pump Control Box is designed with Auto, HI and LOW modes, which turn the lamps and the pump on
stop after hours and off periodicaly. It simulates an outdoor daily cycle to offer the best growing condition.
G. Installation steps of water pump
1. Unscrew the screws on 2. Unplug the water pipe
both sides of the motor. covering the motor
and remove the motor.
G.
Question Answer
Pump will stop under this situation and Low water alarm in water tank will be red warning
Pump was running without water
need fill in water.
What type of lamps can be used in The lamps used in your GrowTank is standard OPCOM 200W (L200B) LED Growth Bulb.
the GrowTank? This is suitable for most plants' growth.
Climbing net : you can use our climbing net, or your own climbing net.
How to use climbing net?
*Vertical : Assist the growth of plants until the plant grows mature, ready to harvest.
(Fig1)
3. Install a new motor on the 4. Put the water pipe on the
water tank, and lock the new motor to complete.
screws on both sides to fix
it.
Ver.: 202006
Manual