Table of Contents
Advertisement
Insufficient cleaning result
Suction turbine is running rough
Brush does not turn
Vibrations during cleaning
In case of faults that cannot be remedied using the table below please contact the customer service.
Cleaning the oater
• Open the cover of the waste water tank.
• Pull out the float casing towards the top.
• Detach locking hooks.
• Clean float and bottom part.
• Assemble the float casing and insert it into the device.
16. ACCESSORIES
Disk brush, red (medium, standard)
Disk brush, natural (white)
Disk brush, black (hard)
Driver plate pad
Pad, red (medium soft)
Pad, green (medium hard)
Pad, black (hard)
Pad, beige (light grain)
Pad, beige (natural hair proportion)
Suction bar, 850 mm, straight
Check the brushes for wear, replace if required.
Suction turbine is running rough
Clean the swimmer.
Check if foreign objects block the brush; remove foreign
object if required.
If over-current switch in the electronics system has been
triggered, turn programme selection switch to "OFF".
Afterwards, set it back to the desired programme.
You might need to use a softer brush.
For the use with all common cleaning tasks.
Made of natural fibres for spot cleaning and polishing.
For heavy soiling and for deep cleaning. For robust floorings only.
For cleaning with pads. With quick change coupling and center lock.
For cleaning and cleanering of all floors.
For cleaning heavily soiled floors and for deep cleaning.
With stubborn soiling and for deep cleaning.
For polishing and refreshing of hard and flexible floorings.
20
1 Swimmer casing
2 Lock hook
3 Float
4 Lower part
Advertisement
Table of Contents
