Subscribe to Our Youtube Channel
Related Manuals for Daewoo DAFL50A
Summary of Contents for Daewoo DAFL50A
- Page 1 DAFL50A Scrubber dryer USER'S MANUAL www.daewoopowerproducts.com Manufactured under license of Daewoo International Corporation, Korea...
-
Page 2: Table Of Contents
INDEX 1. SAFETY ..............................3 2. SAFETY INSTRUCTIONS ........................5 3. FUNCTION ............................... 6 4. PROPER USE ............................6 5. OPERATING AND FUNCTIONAL ELEMENTS ..................7 6. OPERATOR CONSOLE ..........................8 7. SYMBOLS ON THE MACHINE ........................ 8 8. BEFORE STARTUP ..........................8 9. -
Page 3: Safety
1. SAFETY The machine is intended for commercial use (e.g. in hotels, schools, hospitals, factories, shopping centers, offices, etc.). Subject to the strict compliance withthe instructions of use, these machines are used for the wet cleaning of hard flooring. These machines are exclusively designed for use in interior zones. Always read the instructions of use and the safety instructions before using the machine for the first time. - Page 4 CAUTION: Do not use the machine in rooms where explosive or highly combustible substances (e.g. gas, solvents, heating fuel, dust, etc.) are stored or processed. These substances electrical or mechanical components of the machine. CAUTION: Do not use the machine for the vacuum cleaning of poisonous,harmful,causticor irritating substances (e.g.
-
Page 5: Safety Instructions
In case of foam or liquid leakage from the machine, the suction unit must be switched off immediately. Further documents ATTENTION: DAEWOO machines and devices are designed such that health risks caused by noise emissions or vibrations can be ruled out according to the current state of science. • • 2. SAFETY INSTRUCTIONS Before using the appliance for the first time, read and observe these operating instruc tions and the... -
Page 6: Function
Safety switch If the safety switch is released, the brush drive shuts off. Danger or hazard levels DANGER For an immediate danger which can lead to severe injuries or death. WARNING For a possibly dangerous situation which could lead to severe injuries or death. CAUTION Pointer to a possibly dangerous situation, which can lead to minor injuries. -
Page 7: Operating And Functional Elements
5. OPERATING AND FUNCTIONAL ELEMENTS 1 Fluff filter 13 Fresh water leveldisplay 2 Battery 14 Rotary handle to incline the vacuum bar 3 Drain hose for waste water 15 nuts for fastening the vacuum bar 4 Holding rail for home base 16 Vacuum bar 5 Fresh water tank 17 Suction hose... -
Page 8: Operator Console
6. OPERATOR CONSOLE 1 Dispiay 2 Brush mode 3 Vacuum mode 4 E c o mode 5 Key 7. SYMBOLS ON THE MACHINE Battery socket Lashing point Mop holder ** Filling level fresh water tank 25% Bow brush change Vacuum bar lowering lever Pedal transport chassis Drain outlet fresh water tank Dirt water discharge hose... - Page 9 Install batteries Install the batteries (see "Care and Maintenance/Install and connect batteries"). Using batteries made by other manufacturers We recommend using our batteries as described in chapter "Care and Maintenance/ Recommended batteries". Charging battery NOTE: The device is equipped with a safety mechanism to prevent total discharge, i.e. when the permissi- ble minimum capacity is reached, the brush motor and the turbine are switched off.
- Page 10 • Detach the battery plug on the unit side. ATTENTION Risk of damage! – Do not connect the charger withthe battery plug on the unit side. – Only use a charger that is suitablefor the installed battery type: NOTE: Please read the operating instructions of the charger manufacturer, especially the chapters on safety instructions! •...
-
Page 11: Operation
9. OPERATION DANGER Risk of injury! In dangerous situations, release the safety switch/drive lever. Filling in detergents - Fresh water • Open the lock of the fresh water reservoir. • Fill fresh water (maximum 60 °C) until the lower edge of the filling nozzle. •... - Page 12 • Add the detergent to the fresh water reservoir. NOTE: If the fresh water tank is empty, the cleaning head continues working without liquid supply. Setting the water quantity • Adjust the water quantity using the regulating button according to the dirt on the floor covering. NOTE: Carry out initial cleaning attempts with low water volume.
-
Page 13: Shutting Down The Appliance
1 Transport chassis pedal in transport position 2 Transport chassis pedal in cleaningposition • Using your foot, move the transport chassis pedal to the required position. Cleaning ATTENTION Risk of damage to the floor covering. Do not operate the appliance on the spot. •... -
Page 14: Transport
• Open the lid of the dosing equipment. • Drain off the dirt water - regulate the water quantity by pressing or bending. • Rinse the waste water tank with clear water. Drain off cleanwater • Unscrew the lock of the fresh water reservoir. 11. -
Page 15: Storage
• When transporting in vehicles, secure the appliance according to the guidelines from slipping and tipping over. 12. STORAGE CAUTION Risk of personal injury or damage! Consider the weight of the appliance whenstoring it. This appliance must only be stored in interior rooms. 13. - Page 16 -Yearly • Have the prescribed inspection carried out by the customer service. Maintenance works - Replace or turn vacuum lips 1 Wear indicator 2 Vacuum lip The vacuum lips must be replaced or reversed if they are worn down to the wear indicator. •...
- Page 17 - Removing the waste water tank • Drain off dirt water. • Lift up the waste water tank and put it aside. - Batteries Please observe thefollowing warning notes when handling batteries: Observe the directions on the battery, in the instructions for use and in the vehicle operating instructions.
- Page 18 Recommended batteries The device requires 2 batteries 1) Complete set (24 V/100 Ah) incl. connecting cable. Insert batteries and connect • Drain off dirt water. • Lift up the waste water tank and put it aside. • Pull out the battery plug. 1 Spacer •...
-
Page 19: Frost Protection
• Remove the support blocks or the foam pieces. CAUTION When the batteries are installed and removed, the stability of the appliance can be compromised; ensure a safe stance. • Remove the batteries. • Dispose of the used batteries according to the local provisions. Maintenance contract To ensure a reliable operation of the appliance maintenance contracts can be concluded with the competent sales office. -
Page 20: Accessories
Insufficient cleaning result Check the brushes for wear, replace if required. Suction turbine is running rough Suction turbine is running rough Clean the swimmer. Brush does not turn Check if foreign objects block the brush; remove foreign object if required. If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF". -
Page 21: Technical Information
17. TECHNICAL SPECIFICATIONS Power Battery: 24V/ 100 Ah Average power consumption: 1000 W Power suction turbine: 500 W Power brush drive: 500 W Max running time: 5 h Vacuuming Vacuum power, air volume (max.): 24 L/s Vacuuming power, negative pressure (max.): 120 kPA (mbar) Cleaning brushes Brush speed: 175 rpm Brush diameter: 510 mm... - Page 22 Transport angle wheel structure diagram...
- Page 23 Sewage tank structure diagram...
- Page 24 Drawing of suction rack structure Structure diagram of clean water tank...
- Page 26 Brush structure diagram Suction structure diagram...
- Page 28 EC DECLARATION OF CONFORMITY Scrubber dryer Model: DAFL50A Brand: We GBR Corp. LTD, Room 1002, 10/F., David House, 8-20 Nanking Street, Jordan, Kowloon, Hong Kong, China, declare under our sole responsibility that this product is in conformity and accordance with the following standards and regulations.
-
Page 29: Warranty
WARRANTY CARD Product model Date of sale Company Serial number Client's signature Username The product is in good conditions and fully complete. Read and agree the terms of the warranty. GUARANTEE The warranty period starts from the date of sale of the products and covers 2 years for all power products. During the warranty period, free failures caused due to the use of poor-quality materials in the production and manufacturer workmanship admitted fault are removed. - Page 30 Manufactured under license of Daewoo International Corporation, Korea...
Need help?
Do you have a question about the DAFL50A and is the answer not in the manual?
Questions and answers