Shutting Down The Appliance - Daewoo DAFL50A User Manual

EN
1 Transport chassis pedal in transport position
2 Transport chassis pedal in cleaningposition
• Using your foot, move the transport chassis pedal to the required position.
Cleaning
ATTENTION
Risk of damage to the floor covering. Do not operate the appliance on the spot.
• Swivel the transport chassis to the cleaning position.
• Turn the program selection switch to the desired cleaning program.
Lower the vacuum bar
• Pull the lever out and press it down; the vacuum bar is lowered.
NOTE:
– For cleaning tiled floors, adjust the straight suction bar in such a way that cleaning is not done at
an angle of 90 degrees to the joints.
– The inclined position and the inclination of the suction bar can be adjusted to achieve better
suction results (see"Adjusting the suction bar").
– If the waste water tank is full, the float closes the suction opening and the suction
turbine runs at an increased speed.
If this is the case, shut the vacuum off and drive to empty the waste water tank.

10. SHUTTING DOWN THE APPLIANCE

• Close the regulatory button for setting the water quantity.
• Release the safety switch.
• Set the program selection switch to suction or vacuuming.
• Briefly drive forward and suck of the remaining water.
• Raise the vacuum bar.
• Swivel the transport chassis to the transport position.
• Charge battery, if required.
Drain off dirt water
WARNING
Please observe the local provisions regarding the wastewater treatment.
• Take the water discharge hose from the support and lower above a suited collection device.
13