Flat Mount Type - Shimano SM-MA-F180P/P2 Dealer's Manual

Installation/removal

Flat mount type

NOTICE
• Use the supplied snap rings. Other models of
snap rings cannot be installed.
TECH TIPS
• If screw [1] loosens (turns counterclockwise), force is
applied via the wire to turn screw [2] in the
tightening direction (clockwise). However, screw [2]
cannot turn any further in the tightening direction.
Accordingly, this prevents screw [1] from turning in
the loosening direction because it is also connected
via the wire. If either screw begins to loosen, force
will be applied to the other screw, thereby turning
the loosened screw in the tightening direction. In
other words, this system prevents the screws from
loosening.
Flat mount type
Select the mount adapter to install based on the combination of the location to use (front /
rear) and the disc brake rotor.
Disc brake rotor size
Location to use
140 mm
Front
SM-MA-F140P/D
Rear
SM-MA-R140P/D
160 mm
SM-MA-F160P/D
SM-MA-R160P/D
SM-MA-R160D/D
14
Screw [1]
Screw [2]