Installation And Connection; Check Delivery Conditions; Transport To The Installation Site; Installing The Machine - PANHANS 116 10 Operating Manual

and Connection
7 Installation
7.1

Check Delivery Conditions

Check the consignment for completeness and possible transport damage. In case of transport damage, please
keep the packaging and inform the shipping company and the manufacturer immediately! Later complaints can-
not be accepted.
7.2

Transport to the Installation Site

The machine is delivered on a transport pallet and is bolted to the bottom of the pallet.

Figure 5: Transport pallet

Be aware of possible crushing hazards when placing the machine (from the pallet to the
floor) by means of a forklift truck or similar. Pay particular attention to your hands and
feet and wear safety shoes and protective gloves as a precaution.
Danger to life when using a forklift truck! Keep a sufficient distance from the forklift truck
and watch its speed. Vehicles with combustion engines also produce toxic exhaust gases.
Wear a breathing mask if necessary.
7.3

Installing the Machine

• Lift the machine slightly by the push bar at the front, move it to the final place of use and park it.
• The machine must be placed on a level, solid and vibration-free surface. The place of installation or opera-
tion must be dry and well ventilated.
• A foundation is not required. The floor must have a load-bearing capacity corresponding to the weight of the
machine. The net weight of your machine can be found in section  5.1 and may be more depending on the
equipment.
• Level out any unevenness of the floor with underlays and with the aid of a machine spirit level.
• There are two mounting holes at the bottom of the front of the machine. If necessary, the machine can be
bolted to the workshop floor via these holes when it is operated stationary.
• The bare parts of the machine are greased to protect them from corrosion.
• Carefully degrease these parts protected against rust with petroleum or benzine.
Fire hazard! Do not smoke and do not light an open fire.

Do not use nitro thinner for cleaning. Painted surfaces of the machine can be damaged.
Dispose of the packaging material in an environmentally friendly way!
BA_PH_116-10_EN_12-22.docx
• Move a pallet truck between the pallet timbers (see   Fig-
ure 5), lift the pallet only a few centimetres and move it to the
immediate vicinity of the installation site.
• Remove transport locks and screw connections between ma-
chine and pallet and store them well.
• Then lift the machine off the pallet with a forklift truck and
place it on the horizontal workshop floor.
Pay attention to the existing danger of tipping
over during transport!
22