Other Safety Precautions (Environmental Protection Measurements) - Famsun TCXT Series Operation Manual

Spouting permanent magnet

Table of Contents

as well as guests, customers, outcomers, and drivers visiting the plant.

If in need to use the tools such as welding equipment or soldering lamp (flame

soldering lamp) etc. for repair or installation, do as best as possible to arrange the

work in a special workshop or on a designated site.

In case of occasional welding or the like work directly in production area or

warehouse, submit a written application to the supervisor in charge beforehand for

written approval. Perform such operations only with specific safety measures in

place, such as laying water soaked canvas or the covering canvas special for the

surrounding area with fire extinguishers readily available. After completion of the

operation, monitor the welding site and the surrounding area for at least 10 hours.

T he gas cutting sparks are very dangerous. They can travel across through the

narrow clearance of walls and drop downstairs or to the next rooms, or even fly off

10m away in distance. If the sparks drop in dusts, fire accident may occur at any

time.

W elding is prohibited on a running conveyor. If the welding work is required, shut

down the equipment first, and then make a thorough cleaning and isolate both

sides of the welding site securely with materials like mineral wool to avoid

connections with other conveying devices, silos or tanks. If the work is to be done

on the chutes or conveying pipes, it is necessary to disassemble them or

disconnect their lower ends with silo or tank and seal them to avoid welding sparks

entering the conveying pipes or silos.

B eware of static electricity

To ensure the safety of electric circuits and avoid explosion as a result from spark

discharge, remove the painting at the electric connections.

1.8 Other safety precautions (environmental protection measurements)

If you decide not to use the equipment any longer after it has been used for a certain

number of years (such as 8-10 years), take the following measures for environmental

protection and parts reutilization.

D rain the fluids inside of the equipment (like motor oil, gearbox oil, brake oil and

coolant etc.) into special containers and send them to the designated workshop.

P ick up the plastic parts for reutilization.

S ort out the metal parts for special handling.

1-6

Table of Contents