Table of Contents
Advertisement
ENGLISH
Problem
An acoustic signal sounds
and the hob switches off.
An acoustic signal sounds
when the hob is switched off.
The appliance switches off.
Residual heat indicator does
not come on.
The power setting changes
between two levels.
The symbols become hot.
There is no signal when you
touch a symbol on the con‐
trol panel.
comes on.
comes on.
and a number come on.
Possible cause
You touched 2 or more sym‐
bols at the same time.
There is water or fat stains
on the control panel.
You put something on one or
more symbols on the control
panel.
You put something on the
symbol
.
The zone is not hot because
it operated only for a short
time.
Power exchange function op‐
erates.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper‐
ates.
Child Lock or Lock operates.
There is an error in the hob.
Remedy
Touch only one symbol at a
time.
Clean the control panel and
wait for a few seconds before
activating again.
Remove the object from the
symbols.
Remove the object from the
symbols.
If the zone operated suffi‐
ciently long to be hot, speak
to the After Sales Service.
Refer to "Daily use".
Put large cookware on the
rear zones, if possible.
Activate the signals.
Refer to "Daily use" > "Off‐
Sound Control".
Switch off the hob and switch
it on again.
Refer to "Daily use".
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an authorised installer.
17
Advertisement
Table of Contents
