Table of Contents
Advertisement
DVR-9404~9408~9416
Chapter 3 Main System Application
Step 2:
Step 3:
[TCP Server]
Allow you to setup GV-System's TCP server. Enable [Assign IP] option to enable the drop
down list at the right hand side. Select the network card within the drop down list and your IP
address will be displayed in Bind IP. The default port number for TCP server is 3550; you may
assign different port by entering the port number in the [Port:] text column.
[Multicast Server]
Allow you to setup the Multicast server; its operation is similar to the TCP server setup
describes above. The default port number for Multicast server is 3650.
Note
If you are using Dynamic IP, GV-Series system will automatically detect the IP Address
per minute and replace IP so as to ensure re-engagement of remote end
RemoteView IP Multicast WebCam and RemotePlayback system.
Page 40
FOR ADDITIONAL QUESTIONS CONTACT TECHNICAL SUPPORT TEAM @ 1 (866) 392-MACE
You can press the play button to review the recording. If you're sure this is
the recording you want then choose [File] > [Save as] > [Change] and in the
following dialog box select PCM 8,000 Hz, 8-bit Mono (the only format
supported) and click OK.
Try to playback this message in [HotLine Alerts] dialog box. Click browse to
locate the file you've just recorded and click the [Play] button to play this
recording. If a format other than PCM 8,000Hz, 8-bit mono is selected then
an error message will pop up and you will not be able to play that recording.
Mace Security Products
Advertisement
Table of Contents
