Switching Off Water Softening - Siemens SR53HS28KE User Manual

salt immediately before the program
start. The amount of softening salt
required depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
Only fill the water softener
▶
reservoir with dishwasher
softening salt.
†The rinse aid container can be
softening salt for dishwashers
corrode.
To ensure that spilled softening
▶
salt is rinsed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
program starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
Depending on the
1
device version
Softening SystemNL
3. Note:Only use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
1
Funnel
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
Fit and close the lid of the
4.
reservoir.
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the indicator.
Remark
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
†The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. You can use
combination detergents with salt
substitutes
a
25