Table of Contents
Advertisement
Abou t t h e LED la m ps
LED lam ps are sensit ive t o st at ic elect ricit y and surge volt age, which m ay dam age t heir com ponent s
and decrease t heir reliabilit y.
Take m easures against st at ic elect ricit y during t he inst allat ion. Do not t ouch t he LED display areas.
The LED lam ps m ay absorb and hold m oist ure during t he LED m odule inst allat ion or if not used for
a long t im e. Therefore, in such cases, t he bright ness m ust be increased gradually during a break- in
period before set t ing t he norm al bright ness.
I f t he LED lam ps are lit wit h 100% bright ness while m oist ure is ret ained, t he t em perat ure will rise very
quickly and t he wat er inside t he lam ps will evaporat e and expand. This will cause t he encapsulat ing
resin t o expand, which m ay lead t o separat ion of t he boundary surface inside t he LED lam ps. This
separat ion can cause t he LED lam ps not t o light up properly.
La m p br e a k - in
Configure the brightness settings as shown below with a video displayed on the LED module.
Aft er a break- in period of approxim at ely 3 hours, t he LED m odule can be used under norm al
condit ions.
Time since start-up: 0
(just after start-up)
Full white
Video content
1 hour
Brightness
50%
value 20%
40%
60%
2 hours
3 hours
70%
80%
English - 4
Normal operation
Normal operation
Advertisement
Table of Contents
