Base Settings - Gigaset W570 Manual

Gigaset W570 / LUG MEA-ZA en / A31008-M2708-M231-1-3Z19 / settings_BS.fm / 10/1/19

Base settings

The base settings are made using a registered handset.
Activating/deactivating music on hold
¤
Menu
Activating repeater support
You can increase the range and signal strength of the base using a repeater. You will need to acti-
vate repeater mode. This will terminate any calls being made via the base at the time.
Prerequisite: A repeater is registered.
¤
Menu
OK (
After activating or deactivating the repeater, switch your handset off and on again
( p. 11).
•
•
Protecting against unauthorised access
Protect the system settings of the base with a system PIN known only to yourself. You will need
to enter the system PIN when, for example, registering/de-registering a handset to/from the
base.
Changing the system PIN
You can change the base's 4-digit default system PIN ("0000") to a 4-digit PIN known only to
yourself.
¤
Menu
PIN: (enter the current system PIN)
Resetting the system PIN
If you have forgotten your system PIN, you can reset the base to the original code 0000:
Disconnect the power cable from the base. Hold down the registration/paging key on the base
while reconnecting the power cable to the base. Hold down the key for at least 5 seconds.
The base has now been reset and the system PIN set to 0000.
All handsets are de-registered and must be re-registered. All settings are reset to the
default settings.
de en fr nl
Settings OK
Settings OK
= activated)
Eco Mode / Eco Mode+ (
you use a repeater, you cannot use Eco Mode or Eco Mode+.
The default encrypted transmission setting is deactivated when repeater mode is
activated.
Settings OK
Telephony OK
System OK Repeater Mode
p. 28) and repeater support cancel each other out i.e., if
System OK System PIN
OK New PIN: (enter your new system PIN)
Base settings
Music on Hold OK (
OK System
= on)
OK
39