CDI TRAXALL 620: TRAXALL 501: TRAXALL 500: User Manual page 11

OVERVIEW TRAXALL 620/501/500 USER GUIDE
Controls and Indicators
LED ARRAY
Three scrolling LED rows indicate transmi er signal strength. Row A is
dedicated to the industry-standard 22 Hz ("Legacy") frequency and thus
can monitor nearly any transmi er system regardless of manufacturer.
Rows B and C indicate signals from CDI's exclusive X-Series
programmable transmi ers. Row B is for a CDI 27.3 Hz transmi er
frequency and Row C is for a CDI 31.3 Hz transmi er.
LEDs will light across the row(s) in progression from le to right as
a detected signal strength increases.
Ba ery Strength Indicator
The Traxall 620 can operate for up to 60 hours on six alkaline AA-Cell
ba eries. Three lithium ba eries can be used for extreme cold-weather
confi gura on in temperatures as low as -40°C.
Green indicates normal (ready) state, amber indicates low charge, and
red indicates ba eries are below their serviceable limit and should be
replaced.
Power ON/OFF
Depress bu on for 3–5 seconds to power up the TRAXALL receiver
(same to power down).
Gain Selec on Switch
Eight sensi vity se ngs are neatly divided and labeled with their
recommended use: PINPOINTING (low sensi vity), WALKING (medium
sensi vity), and STATIONARY (high sensi vity).
Speaker Mute
On/Off pushbu on mutes speaker.
LED Brightness
Pushbu on increases brightness of last LED.
Speaker Mute and LED Brightness
bu ons will also reset the Passage
Indicator Output Port when held
down together for 3–5 seconds.
Page 11 of 32