Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sumner Fab-Mate
Summary of Contents for Sumner Fab-Mate
- Page 1 OPERATOR’S MANUAL Fab-Mate 7514 Alabonson Rd. Houston, Texas 77088 281-999-6900 281-999-6966 (fax) 1721 Bishop St., Unit #4 Cambridge, Ontario N1T 1N5 519-623-2300 519-623-0744 (fax) Haybrook Industrail Estate, Halesfield 9, Unit A6, Telford, Shropshire, UK TF7 4QW 011-44-1952-586517...
-
Page 2: Table Of Contents
INDEX Operator Safety Instructions Specifications Assembly Instructions Moving Fab-mate to work area (no load) Moving Fab-mate (with load) Attaching Lift Cable to Object Elevating Load Lowering Load Removing Mast Caster Brakes Lift Diagram Maintenance Instructions Installing New Cable Load Lifting Cable... -
Page 3: Operator Safety Instructions
Use only on solid level surface. Keep work area Do not climb on Fab-mate or put side load on mast. clear of clutter and debris. Test load balance before lifting. Do not exceed rated Do not operate during storms. -
Page 4: Specifications
OPERATOR SAFETY INSTRUC- ASSEMBLY INSTRUCTIONS TIONS (CONTINUED) 1. Turn base upside down. 2. Insert the four casters into the base legs. 3. Secure the casters into the base by installing the four supplied setscrews into the base legs and then tighten with allen wrench. Ensure Wear proper clothing. -
Page 5: Moving Fab-Mate To Work Area (No Load)
3. MOVING FAB-MATE TO WORK AREA (WITH LOAD) WARNING When properly 1. When the Fab-Mate is used to transport a installed, the load, the load should be placed on the base winch handles legs for positive control of the lift. -
Page 6: Attaching Lift Cable To Object
7. Removing Mast 1. Turn handle on winch clockwise to elevate. Note: Caster brakes should always be locked 2. Never allow lift cable loop, when removing mast. Counter Weight, or line shackle to contact “Tee 1. Place crowbar Pry tab Head”... -
Page 7: Lift Diagram
9. Lift Diagram Tee Head Mast Load Line Counter Weight Winch Handle Winch Line Hook Base Caster Brake Caster... -
Page 8: Maintenance Instructions
5. For proper brake adjustment see “Troubleshooting” section on page 9. Replacing the Cables: A. Load Lifting Line 1. Lay Fab-Mate across supports with the winch facing up. 2. Remove the gear cover. 3. Disengage load ratchet dog and pull wire rope... -
Page 9: Troubleshooting
WARNING WARNING Modifying the Fab-Mate in any way Replace all worn or damage parts only can cause injury or death! with Sumner parts. TROUBLESHOOTING PROBLEM CAUSE SOLUTION Winch Brakes need adjusting. See below Fab-Mate not holding the load. Brake pads are worn. -
Page 10: Maintenance Record
MAINTENANCE RECORD Lift Model Number_____________________ Lift Serial Number_____________________ Service Performed: __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date __________________________________________________________________________ Action Date...