Husqvarna 455 Rancher Operator's Manual page 14

3. Push the air purge bulb (B) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
B
4. Push the decompression valve (C).
To start the product on page 14 for
5. Continue to
more instructions.
To prepare to start with a warm engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the choke control out and then push the choke
control in again.
3. Pull the start/stop switch up.
14
A
C
The chain brake must be
4. Push the air purge bulb approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
5. Push the decompression valve.
To start the product on page 14 for
6. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
You must keep your feet in
If the saw chain rotates at
Do not twist the starter
589 - 006 - 14.03.2022