The packaging must not be used as a lifting device unless otherwise indicated (such as a pallet). The product should be stored in a safe, clean, dry, vibration-free location. If the product is to be stored for 12 months or more, an inspection by Woods Air Movement service centre before installation is advised.
3. INSTALLATION (MECHANICAL) It is recommended that suitable safety guards form part of the installation wherever necessary. We recommend that an air filter is fitted within the ductwork to reduce the accumulation of dirt on the fan impeller. An excessive build up of dirt could lead to imbalance of the impeller and vibration problems. Where the product is delivered packaged, the packaging must be considered as a protective device only, and must not be used as a lifting aid unless otherwise indicated.
The product contains rotating parts and electrical connections, which can be a danger and cause injury. If there is any doubt that a safe and reliable installation of the fan can be assured, Woods Air Movement or their representative should be contacted for advice. See section 10 for connection diagrams.
Information on all aspects of overhaul/extended maintenance is available from Woods Air Movement service centre. After overhaul/extended maintenance the box fan must be safely and correctly installed...
7. FAULT-FINDING Fault-finding must be carried out on the product by appropriately qualified personnel using the correct tools and equipment. If in doubt please seek advice from Woods Air Movement. 7.1 Electrical 7.1.1 Isolate the box fan and controls from the electrical supply, check that the electrical connections to the product are secure and wired in accordance with the connection diagram, 7.1.2...
9. ELECTRICAL CONNECTION DIAGRAM Connection Diagram – EC Box Fan and iFan Controller 1 phase wire diagram 3 phase wire diagram ä l t i r s s i ● : s t ä l t i r s s i...
10. INSTALLATION EXAMPLES Fig. 6 - Floor Mounted – All Sizes (Correctly Mounted) Fig. 7 - Ceiling Mounted – Spigot Sizes 125, 150, 200 and 250mm only (Correctly Mounted) IMPORTANT NOTE: When mounting on the ceiling in the normal position, please ensure suitable drop rods are used.
Page 10
Fig. 9 - Wall Mounted Vertical Vertical Air Fig. 10 - Wall Mounted Vertical Wall Flow Up – Sizes 125, 150, 200 and 250mm Mounted Vertical Air Flow Down – Only (Correctly Mounted) All Sizes (Incorrectly Mounted)) Fig. 11 - Wall Mounted Horizontal – All Sizes (Incorrectly Mounted)
Page 12
Woods Air Movement delivers smart and energy efficient Air Movement and Fire Safety solutions to support every application area. We offer our customers innovative technologies, high quality and outstanding performance supported by more than fifty years of accumulated industry application experience.