Table of Contents
Advertisement
the side of the water tank (Figure 1, Item 5) If the water tank is low on water,
open the water tank fill tower (Figure 1, Item 3)and fill the water tank with water.
•
Check the pump engine fuel (Figure 3, Item 1) and oil levels (Figure 3, Item 5) as
needed, fill the pump engine with fuel and oil as specified in the engine manual
that came with your QTAC. For more information, see the Pump Operation
Manual and the Honda Owner's Manual.
PUMP OPERATION
Priming the Pump after an Extended Period of Use
The QTAC pumps are a self-priming pump, meaning they do not need to be primed
before every use. However, if the pump is being started after not being in use for more
than 12 hours, it may be necessary to add water to the primer port (Figure 2, Item 2) to
ensure proper suction. To do so, simply pour water into the primer port until it is full,
secure the cap and start the engine.
Tank Fill Requirements:
MAX FILL PRESSURE: 100 PSI
MAX FILL RATE: 150 GPM
Tank Fill Through the Fill Tower
1. Open the fill tower and fill the tank. (Figure 1, Item 3)
(For filling the tank by way of draft suction, see page 12)
Page | 10
Advertisement
Table of Contents
