XP-PEN Deco Series Quick Manual

Hide thumbs Also See for Deco Series:

Deco Series PenTablet Quick Guide

I. Overview

1. Lanyard hole

2. Power key: Press and hold it for 3 seconds to turn on or off the pen tablet

3. USB-C port

4. Shortcut keys

5. Indicator 1

a. Flashing: Stylus is in range, but not touching the work area.

b. Solid: Stylus is touching the work area and functions properly.

c. No light: Stylus is out of detection range.

6. Indicator 2

In blue status:

a. Flashing slowly: Bluetooth disconnected

b. Flashing quickly: Waiting for pairing Bluetooth (Long press the shortcut key on the

top left for 3 seconds)

c. Solid: Successfully paired

In red status:

a. Flashing: Low battery (20% battery remaining)

b. Solid: Charging

c. No Light: Fully charged

In purple status:

The red and the blue indicator are both on simultaneously

7. Workarea

* All descriptions and pictures shown are for reference only and may differ from the actual

products.

Table of Contents

Do you have a question about the Deco Series and is the answer not in the manual?

Page 1 Deco Series PenTablet Quick Guide I. Overview 1. Lanyard hole 2. Power key: Press and hold it for 3 seconds to turn on or off the pen tablet 3. USB-C port 4. Shortcut keys 5. Indicator 1 a. Flashing: Stylus is in range, but not touching the work area.
Page 2 II. Accessories Stylus, Nib, Nib extractor, Cable, Adapter, Bluetooth receiver * All descriptions and pictures shown are for reference only and may differ from the actual products. III. Getting Started Wired Connection Connect the pen tablet to your computer. And make sure you can use the stylus to control the cursor.
Page 3 IV. Download and Install the Driver 1. Make sure your pen tablet is connected correctly to the computer. 2. Visit the XP-PEN website (www.xp-pen.com), choose “Support” section and click “Download”. According to your computer system and product model to download the latest driver.