AS/NZS 60335.2.35 / IEC 60335.2.35 CE/C-Tick * The CFEWH Series 2 Series requires hard wired circuits. If installing a RCCB breaker, minimum acceptable is Super Immune (Type A-SI). ** In accordance with AS 3498:2020 if factory set to either 45°C 50°C...
HYGEINE PURPOSES CFEWH SERIES 2 The CFEWH Series 2 is commonly installed close to point of use as shown in the diagram below – CFEWH SERIES 2 PERSONAL HYGEINE SANITARY FIXTURE CONNECTION. Where the CFEWH Series 2 heated water temperature is factory limited to deliver a maximum of 45⁰C OR 50⁰C, PIPE 1...
Where a failed component or CFEWH is replaced or repaired under warranty, MicroHeat will incur all associated costs. However, where the CFEWH is installed outside the boundaries of a metropolitan area to be defined by MicroHeat or further than 35 km from an Accredited Service Agent, the cost of transport, insurance and travelling costs between the nearest MicroHeat Accredited Service Agent’s premises and...
Need help?
Do you have a question about the CFEWH Series and is the answer not in the manual?
Questions and answers