Table of Contents
Advertisement
Keep fingers behind the finger guards on the
probes.
When
the product has already been connected
to the line being measured,
do NOT
touch the
input terminal that is not in service.
Disconnect the test leads from the circuit before
changing the mode.
When the voltage to be measured exceeds 36V
DC
or 25V
AC,
the operator
shall
be
careful
enough to avoid electric shock.
Misuse of mode
or range can lead to hazards,
be cautious. " 9" will be shown on the display
when the input is out of range.
Low
level
of a battery
will result
in incorrect
readings.
Change
the
batteries
when
battery
level is low. Do not make measurements when
the battery door is not properly placed.
Advertisement
Table of Contents
