Change The Charcoal Filter - Sharp SMO1461GS Installation Manual

Turn two full turns on each screw
The Filler Block is only used for recessed cabinet and front
overhang cabinet (see the type of the cabinet on pages 8 - 9). Place
the Filler Block to the cabinet bottom before installing the oven.
5. Tighten the outer two screws to the top of the microwave oven.
While tightening screws, hold the microwave oven in place against
the wall and the top cabinet.
Cabinet front
Cabinet bottom
Microwave oven top
6. Install grease filters. See the Operation Manual included with
the microwave.
STEP-BY-STEP INSTALLATION GUIDE
Cabinet mounting bolt
Washer
Washer
Filler block
Equivalent to
depth of cabinet
recess
Cabinet mounting bolt
C5.

CHANGE THE CHARCOAL FILTER

The charcoal filter is used for nonvented, recirculated installation.
The filter should be changed every 6 to 12 months depending on use.
1. Remove two screws of the louver on the top of the oven by using
a #1 Phillips screwdriver.
Louver
2. Open the door, remove the louver and take the used charcoal
filter out.
3. Install the new charcoal filter. When properly installed, the wire
mesh of the filter should be visible from the front.
4. Replace the louver and the screws.
19
Charcoal Filter Louver Screws
Charcoal
Filter
E