Table of Contents
Advertisement
Available languages
Available languages
A2.
USE TOP CABINET TEMPLATE FOR PREPARATION
OF TOP CABINET
Drill holes for the top support screws, a hole large enough for the
power cord to fit through and a cutout large enough for the exhaust
adapter.
1. Read the instructions on the Top Cabinet Template.
2. Tape the template underneath the top cabinet bottom.
3. Drill the holes, following the instructions on the Top Cabinet
Template.
CAUTION
Wear safety goggles when drilling holes in the
cabinet bottom.
A3.
CHECK FOR PROPER DAMPER OPERATION
1. Place the microwave in its upright position with the top of the
unit facing up.
2. The exhaust adapter is only used for top exhaust and rear outside
exhaust. The exhaust adapter is not used on models vented for
recirculation exhaust.
3. Make sure tape securing damper is removed and damper pivots
easily before mounting microwave.
Exhaust adapter (not included on models shipped for recirculation exhaust)
Blower plate
4. Attach the exhaust adapter to the blower plate by sliding it into the
guides. Secure the adapter with one Sheet Metal Screw provided.
Sheet metal screw
Guide
Blower plate
5. You will need to make adjustment to ensure proper alignment
with your house exhaust duct after the microwave is installed.
E
STEP-BY-STEP INSTALLATION GUIDE
Damper
Back of microwave
Guide
A4.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during installation. If
filler blocks are not used, outer case damage may occur from over
tightening screws.
Note: If your cabinet is metal, use the nylon grommet around the
power cord hole to prevent cutting of the cord. We recommend using
filler blocks if the cabinet front hangs below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord through
hole in bottom of top cabinet. Keep it tight throughout steps 1-4. Do
not pinch cord or lift oven by pulling cord.
1. Lift microwave, tilt it forward and hook slots at back bottom edge
onto four lower tabs of mounting plate.
2. Rotate front of oven up against cabinet bottom.
3. Attach the microwave oven to the top cabinet.
4. Insert two cabinet mounting bolts (
outer top cabinet holes. Temporarily secure the oven by turning
the screw at least two full turns after the threads have engaged.
(It will be completely tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially when mounting
flush to the bottom of cabinet.
Nylon grommet
Metal cabinet
Turn two full turns on each screw
12
1
/
" x 3" / 0.6 x 7.6 cm) through
4
Power cord
Power cord
hole
Cabinet mounting bolt
Washer
Advertisement
Table of Contents
