Epson TM Series Development Manual page 32

The power is Upon completion of EndInsertion
turned off method, the following retune values
during insertion are set:
RC: OPOS_SUCCESS
RCE: 0
The result of data analysis is
notified by ErrorEvent.
RC and RCE of the ErrorEvent are as
follows:
When power OFF state is detectable
RC: OPOS_EX_NOHARDWARE
RCE: 0
When
detectable
RC: OPOS_E_OFFLINE
RCE: 0
The paper is
Upon completion of EndInsertion
removed during
method, the following retune values
insertion
are set:
RC: OPOS_SUCCESS
RCE: 0
The result of data analysis is
notified by ErrorEvent.
RC and RCE of the ErrorEvent are as
follows:
RC: OPOS_E_EXTENDED
RCE: OPOS_EMICR_NOCHECK
The line is Upon completion of EndInsertion
turned off during
method, the following retune values
insertion
are set:
RC: OPOS_SUCCESS
RCE: 0
The result of data analysis is
notified by ErrorEvent.
RC and RCE of the ErrorEvent are as
follows:
RC: OPOS_E_OFFLINE
RCE: 0
The timeout time
Upon completion of EndInsertion
is up
method, the following retune values
are set:
RC: OPOS_SUCCESS
RCE: 0
The result of data analysis is
notified by ErrorEvent.
RC and RCE of the ErrorEvent are as
follows:
RC: OPOS_E_ILLEGAL;
RCE: OPOS_EX_TIMEOUT
power OFF state
28
APPLICATION DEVELOPMENT GUIDE
MICR (EPSON TM Series)
Version 3.00 Feb. 2019
Upon completion of EndInsertion
method, the following retune values
are set:
When power OFF state is detectable
RC: OPOS_E_ILLEGAL
RCE: OPOS_EX_BUSY
When power
detectable
RC: OPOS_E_OFFLINE
RCE: 0
There is no notification by event.
is not
Upon completion of EndInsertion
method, the following retune values
are set:
RC: OPOS_E_EXTENDED
RCE: OPOS_EMICR_NOCHECK
There is no notification by event.
Upon completion of EndInsertion
method, the following retune values
are set:
RC: OPOS_E_OFFLINE
RCE: 0
There is no notification by event.
Upon completion of EndInsertion
method, the following retune values
are set:
RC: OPOS_E_ILLEGAL;
RCE: OPOS_EX_TIMEOUT
There is no notification by event.
OFF state is not