Alinco DR-MD500 Operation Manual page 7

VFO / MR
Scan
FM Radio
Alarm
Record Switch
Record
SMS
Dial
Monitor
Main CH Switch Choose channel A or channel B as the main channel
Hot Key 1~6
Work Alone
Nuisance Delete
Digi Monitor
Sub CH On/Off
Priority Zone
Program Scan
Enhanced Sound In digital channel, switch the microphone tone to normal or enhanced
Last Call Reply
Switch ChType
Roaming
Max VOL Set
Slot Set
Zone Select
A CH Mute
B CH Mute
Roaming Set
Zone Up
Zone Dn
Exit
Menu
Hot Key Setting for P1, P2, P3, P4, P5, P6, PA-PD
Enter radio Menu-Settings-Radio Set-P1-P6, PA-PD, sub menu. User can choose settings for Hot
Keys 1-6.
Hot Key function details must be setup in CPS - Public - Hot key.
is only valid for analog channel.
Switch between VFO mode and memory channel mode.
Scan on/off
FM radio on/off
Long press the key to start alarm, short press again to exit the alarm.
Enable/disable the recording function
Start/stop recording. When stop recording, the radio will remind repeat
or send the record. Radio can record both TX and RX voice during the
call.
In digital mode, press to enter into SMS messages
Start the manually dial
Monitor the weak signal or the signal with unmatched ID.
Selects Hot Keys 1-6 Note: Hot key setup details on next page
Turn on/off the work alone function.
During scanning, press the key to skip the unwanted channel
In DMR mode, press the key to turn on/off digital monitor
Turn on/ off the sub channel
Switch to Priority Zone
"Press the key to start the scan in VFO channel scan start and end
frequency must be programmed in CPS."
mode
In digital channel, press the key to access the last call and press PTT to
call back.
Switch the channel type (Analog, Digital, Ana+Dgi, Dgi+Ana)
In standby, press the key programmed as "Roaming" to search and
lock on the repeater with strongest signal. (Note: After lock on a
repeater, the radio will return to last frequency only after channel or
frequency is changed. The repeater frequency list must pre-
programmed in CPS.)
In standby, press the key programmed as "Max Volume", will enable
users to set the maximum RX volume.
Choose Slot for current channel, this function is only valid in repeater
mode.
In standby, press the programmed "Zone Select" key, it will allow you
input the zone number and then press confirm key will switch to the
zone.
Mute the main channel
Mute the sub channel
Enter into Roaming menu quickly
Switch the zone upwardly
Switch the zone downwardly
Exit the menu (only for A-D short press)
Enter into the menu (only for A-D short press)
7