Ford Transit 2014 Owner's Manual page 20

E188215
1. Allow the top tether to drop behind the
seat backrest.
2. Attach the top tether to the anchor bar
located on both outboard seats.
The anchor fittings are only suitable for
child restraints conforming to Australian
Standard AS1754-2004 or later. If your
child restraint does not have an approved
latched hook attaching clip as shown, you
should consult an approved restraint fitting
station.
WARNINGS
Always make sure that the attaching
clip is properly engaged with the
anchor fitting and the tether strap
length is adjusted to remove any slack.
Always make sure that the locking
mechanism of the rear seat backrest
is fully engaged when in the upright
position, by attempting to pull it down
again.
Transit (TTG) Vehicles Built From: 05-07-2014, Australia, EK3J-19A321-BDA (CG3612enAUS) enAUS, Edition date: 06/2014, First Printing
Child Safety
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Make sure that the top tether strap
is not slack or twisted and is properly
located on the anchor point.
E166781
Note: You may need to raise or remove the
head restraint to ease installation. See
Head Restraints (page 77).
ISOFIX Anchor Points
Use a top tether as an anti-rotational
device when using the ISOFIX
system.
Your vehicle has ISOFIX anchor points that
accommodate universally approved
ISOFIX child seats.
The ISOFIX system has two rigid
attachment arms on the child seat that
attach to anchor points on the second row
seats, where the cushion and backrest
meet. Tether anchor points are fitted to
the underside or rear of the second row
seats for child seats with a top tether (as
shown in the top tether information).
18
WARNINGS
WARNING