JVC KD-X351BT Instruction Manual page 31

INSTALLATION/CONNECTION
Wiring connection
JVC Amplifier * 1
Signal cord (not supplied)
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
Separate red wire
Make this connection if your vehicle
factory wiring harness does not
have "12 V ignition switch" wire.
Front output/3-way crossover: Mid range output
Rear/subwoofer output/3-way crossover: Woofer output
Light blue/yellow
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (12 V 350 mA)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker/For 3-way crossover: Mid range speaker (right)
Gray/black
White: Front speaker/For 3-way crossover: Mid range speaker (left)
White/black
Purple: Rear speaker/For 3-way crossover: Tweeter (right)
Purple/black
Green: Rear speaker * /For 3-way crossover: Tweeter (left)
2
Green/black *
2
Antenna terminal
Microphone input jack ( 11)
Blue: To power antenna
Blue/white: To amplifier
(Not used)
IMPORTANT
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult
your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Brown
Firmly connect the ground
* 1
wire of the amplifier to
the car's chassis to avoid
damaging the unit.
You can also connect a
* 2
subwoofer speaker directly
using this lead without
an external subwoofer
amplifier. For setting,
21.
Recommended connection
ENGLISH
31