Each tape drive is required to have a dedicated bus to the initiator, referred to as point-to-point connection. SAS architecture does not support multiple tape

drives connected to a single host adapter port. The maximum SAS cable length that can be used to connect the host adapter to the tape drive varies

depending on the type of SAS connection. See

Connecting power

Steps to install and connect a power cable to your unit.

Running drive diagnostics

Run the Standalone Diagnostic procedure.

Installing device drivers

A device driver is ﬁrmware that enables the tape drive to interact with various servers.

Conﬁguring the tape drive to a server/host

Steps for conﬁguring your tape drive to a server/host.

Updating ﬁrmware

It is the customer's responsibility to ensure that this drive has the current ﬁrmware. Several options are available for updating drive ﬁrmware.

Registering for My Support

My Support registration provides email notiﬁcation when new ﬁrmware levels are updated and available for download and installation.

Avoiding drive damage

To avoid static electricity damage when the drive is handled, use the following precautions.

Limit your movement. Movement can cause static electricity to build around you.

Always handle the drive carefully. Never touch exposed circuitry.

Prevent others from touching the drive.

Before you unpack and install the drive into an enclosure, touch its static-protective packaging to an unpainted metal surface on the enclosure for at least 2

seconds. This procedure reduces static electricity in the packaging and your body.

When possible, remove the drive from its static-protective packaging and install it directly into an enclosure without setting it down. When this action is not

possible, place the drive 's packaging on a smooth, level surface and place the drive on the packaging.

Do not place the drive on the cover of the enclosure or on any other metal surface.

Unpacking the drive

Unpack the drive and store the packaging for future moves or shipping.

Attention: If you return the unit for service, ship it in its original or equivalent packing material, or the warranty might be invalidated.

1. Inspect the unit for shipping damage. If there is damage, do not install the unit, and report the damage immediately. Contact your place of purchase.

2. Locate the label on the bottom panel of the unit with the machine type, model number, and serial number of the unit. Make a note of these numbers and

store them in an easily accessible place. If you must contact Technical Support, you are asked for these numbers.

Verifying the shipment

Ensure that the following items are included in the shipment.

Power cord (For the appropriate cord for your country or region, see

IBM® Ultrium Cleaning Cartridge

Single-connector SAS HD wrap tool (optional)

Rack Mount kit (optional)

IBM Half Height LTO Tape drive (SAS) Installation Quick Reference, GC27-2276-03

IBM documentation for TS22xx Tape Drives along with translated warranty information, and translated Safety and Environmental notices. See

Environmental

notices.

SAS cables are not part of the shipment and must be ordered separately.

8 IBM TS22xx Tape Drives

Optional features

for the maximum cable length that can be used.

Ordering optional features, replacement parts, and power

cords.)

Safety and

Table of Contents

Avoiding Drive Damage; Unpacking The Drive; Verifying The Shipment - IBM TS22 Series Manual