Korg KAOSS PAD Entrancer Owner's Manual page 15

FAQ
Q1: A video effect is not applied when I touch the
pad
A: Check the following points.
1) Is the control lever in the correct position?
>> The video effect is applied only when the
control lever is in the COMBI or VIDEO
mode.
2) Try adjusting the FX BALANCE knob.
>> The FX BALANCE knob adjusts the video
only if the control lever is set to VIDEO.
3) Is the PAL/NTSC switch in the correct
position?
>> You must turn off the power before changing
the position of this switch.
Q2: I can't sample a still image successfully.
A: In order to sample a still image, the control
lever must be in VIDEO mode.
>> Set the control lever to VIDEO mode. Then
use the MUTE/FREEZE lever to freeze the
image and press the SAMPLE (1 or 2) button
to sample the image.
Q3: In COMBI mode, the VIDEO effect applies
only to still images.
A: If a still image is being played back, the
video effect will apply to the still image.
>> To stop playback of the still image,
temporarily set the control lever to VIDEO,
and then press the SAMPLE button to stop
the still image playback.
Q4: In COMBI mode, turning the FX BALANCE
knob does not change the video effect.
A: In COMBI mode, the FX BALANCE knob
applies only to the audio effect.
Q5: I want to store video effect and graphic
pattern playback together in memory.
A: You can't store an effect program and graphic
pattern playback together in the PROGRAM
MEMORY 1–8 keys.
Q6: The graphic pattern disappears when I
change the video effect.
A: Graphic pattern playback will stop when you
re-select the effect program.
>> If you want to display the pattern again, you
must re-enter graphic pattern mode.
If you want to apply a video effect to the
pattern, first select the desired video effect,
and then enter graphic pattern mode and
select the pattern.
Q7: Can I mix the two video inputs VIDEO 1 and
VIDEO 2?
A: The KAOSS Pad KAOSS PAD Entrancer does
not have input mixing capability.
>> The video effect program applies to the input
you select; either VIDEO 1 or VIDEO 2.
However, you can operate the input select
switch to obtain a result similar to mixing a
sampled video clip or still image.
About demo mode
Entering demo mode
Set the control lever to COMBI and hold
down the FUNCTION key while you turn on
the power. (The FUNCTION key will light
momentarily.)
Using demo mode
When the control lever is set to COMBI and
you do not perform any operation for five
seconds, the demo will start. (Pad motions
will be automatically executed as the demo
mode advances through the COMBI
programs.) Only the COMBIs will be
demoed. Sampling programs (94–99) will be
skipped.
Pausing demo mode
The KAOSS PAD Entrancer will pause the
demo mode when you perform any
operation, and will re-enter the demo mode
if no further operation has been performed
for five seconds.
Exiting demo mode
Turn off the power, and then turn it on again
in the usual way.
13