Motorola FOMA M1000 Instruction Manual page 88

NOTE
• When you make a video call by setting Camera off, you will still be charged for a video call.
• If a video call fails, the following messages are displayed on the display. However, depending on the other
party's phone model and subscription to network services the displayed message may not correspond to the
actual conditions.
The number you have dialed is not in service. Check
the number and try again.
The number you have dialed is busy.
The number you have dialed is in area with no radio
wave or the phone may be switched off.
Connection failed.
• Video calls fail when you dial to phones that do not support the video call function, are in area with no radio
wave, or are switched off. If you make a video call to phones that do not support the video call function, the
call will be cut off and a "Connection Failed" message is displayed. Tap [$$ Voice] to redial as a voice call.
However, this redialing may not work if you call an ISDN synchronous 64K or PIAFS access point or an ISDN
video phone incompatible with 3G-324M (as of XX, 2004), or if you dial a wrong number. Note that you may
be charged for the call.
• If you dial 110, 119, or 118 using the video call function, the call will automatically be connected as a voice
call.
• During a video call, you cannot make another voice/video call.
• During a video call, incoming call/video calls are rejected, and the Missed call screen is displayed when the
call ends.
• If you receive an SMS/email message during a video call, the FOMA handset rings and displays an icon ($$
etc.) on the Status bar. Tap the icon to check the message while talking. However, you cannot receive a
message sent via data communication. 3 P316
• When talking with the speakerphone, always keep the FOMA handset away from your ear.
Sending Tone Signals (DTMF)
You can send tone signals (DTMF) during a video call.
a
Tap [$$] during talking
b
Tap the numbers to send
The numbers you tapped are sent as tone signals.
• Tap [$$] to close the DTMF entry screen.
86
Message
Displays the DTMF entry screen.
Reason
You have dialed a phone number not in use.
The line is currently engaged.
The number you have dialed is in an area with no
radio wave or the power may be turned off.
Reasons other than the above.