Loading A Layout; Configuring A Client Pc - Miranda Kaleido-X16 Quick Start Manual

2 Setting Up the Kaleido-X16 Multi-Viewer

Loading a Layout

The message "Access granted" will appear on the LCD display if the login is successful. If a mouse is
connected to the RCP2, then you should be able to see and move the mouse pointer on the monitor
wall.
9. Press any of the LAYOUT PRESETS buttons to load a predefined layout on the monitor wall.
If your system was configured prior to shipment, then a layout will appear on all displays. Otherwise,
a gray screen will appear with the following message in the middle:
"No layout has been assigned to this room. Please load a layout."
Note: To access other layouts, press the LOAD button. To assign a layout to a preset button, press and hold
the button for more than six seconds while the desired layout is showing on the monitor wall.
Loading a Layout
To load a layout on the monitor wall:
1. Connect a mouse to the RCP2 (if available) and log on to the Kaleido-X16 from the RCP2, if you have
not already done so (see "Using the Kaleido-RCP2 with Default Settings" on page 14).
Alternatively, connect the mouse directly to one of the USB ports on the Kaleido-X16 frame.
2. Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a monitor), and then
click Load layout on the shortcut menu.
Monitor wall shortcut menu
A layout browser appears on the displays associated with the current room.
3. Select the layout you wish to load from the list of available layouts for this room, and then click OK.
The selected layout appears on the room displays.

Configuring a Client PC

The client PC that you will use to communicate with the Kaleido-X16 multi-viewer (via XAdmin and XEdit)
and the multi-viewer itself must have IP addresses within the same subnet. The following procedure
16