Changing The Ip Address From The Monitor Wall - Miranda Kaleido-X16 Quick Start Manual

System IP address 10.0.3.70
Network mask 255.255.0.0
Gateway 10.0.0.1
Note: If the IP address of the multi-viewer has been changed (i.e. it no longer corresponds to the as-
shipped configuration), it is still possible to determine the current setting. To determine the IP address of
your Kaleido-X16 multi-viewer, see "Finding the System IP Address and Application Version" below.

Changing the IP Address from the Monitor Wall

The IP address, system name, and other parameters can be set via a control panel on the monitor wall.
To change the IP address of the Kaleido-X16 from the monitor wall:
1. Connect a mouse to one of the USB connectors of the Kaleido-X16.
2. Connect a keyboard to one of the USB connectors of the Kaleido-X16.
3. Right-click anywhere on the monitor wall, point to Monitor Wall (if you clicked a monitor), and then
click System configuration.
The System Configuration window appears.
4. Click the Ethernet tab.
5. Type the required frame IP address, network mask, and gateway address in the appropriate boxes.
6. Click OK.
7. When prompted to restart the system to apply your changes, click Yes.
Finding the System IP Address and Application Version
To find the system IP address and application version:
1. Connect a mouse to a USB connector: either the USB at the front of the frame or one of the two USB
connectors on the rear connector panel.
2. Right-click anywhere on the monitor wall. On the shortcut menu, point to Monitor Wall (if you clicked
a monitor), and then click Show dashboard to display the dashboard associated with the current
head. A small window appears, revealing the frame IP address and the system version. Take note of
these values—they will be used later in the configuration process.
Kaleido-X16
Quick Start Guide
13