Table of Contents
Advertisement
AES 7007 Security Subscriber
Selecting the 12 V DC power option with the 7085UE5 transceiver results in power output of 50% to
Important!
60% of full radio capacity.
7007 – Standby w/o backup battery: 200 mA max. (1.1 A Transmitting)
7007 – Standby w/ charged backup battery: 200 mA max. (1.1 A Transmitting)
7007 – Standby + charging backup battery: 900 mA max. (1.8 A Transmitting – maximum)
Note:
The keypad interface circuit on the subscriber draws current when the subscriber is powered off but
still wired to an active ECP/DSC keypad interface bus. The LED near J1 flashes during this
condition. Remove the keypad interface bus wires to remove all subscriber current draw.
Operating Temperature: 32°F to 120°F (0°C to 49°C)
Storage Temperature: 14°F to 140°F (–10°C to 60°C)
Relative Humidity: 0 to 93% RH, non-condensing
Dimensions: 12 in. H × 8 ¼ in. W × 4 ¾ in. D (29.2 cm H × 18.4 cm W × 12 cm D)
Weight: 5.8 pounds (1.3 kilograms) without battery
10 pounds (2.9 kilograms) with 10 Ah battery
Enclosure Material: Molded UL-recognized polymer
Finish Color: Gray
Alarm Signal Inputs:
•
7007 Zone Input – four each EOL resistor type – All inputs supervised with trouble and restore
•
Alarm Panel Siren/Bell Input
•
Alarm Panel Phone Line Input:
7094A IntelliPro Module
•
Alarm Panel 4 Wire Keypad Bus
Industry standard 4 Wire Addressable Keypad Bus (ECP Bus)
Low AC Voltage (low AC voltage limit: 85 V AC) and AC Failure
Low Battery (low battery voltage limit: 11.6 V DC)
Zone Input Ground Fault (impedance to earth ground is less than 50 kΩ)
Antenna Cut
Battery Charger Failure
Output Power: 2 Watts
Frequency Range: 450–470 MHz standard (Contact AES for other UHF and VHF frequencies.)
Current Consumption
Environmental Specifications
Mechanical Specifications
Inputs
Reporting
Transceiver
8
Part No. 40-7007 Rev. 2B, 4/9/2022
Advertisement
Table of Contents
