Table of Contents
Advertisement
AES 7007 Security Subscriber
7.3
Trouble Output
Terminal J4 – Relay Contacts Rating — 24 V DC 1A Maximum Resistive Load. Unsupervised.
•
8. Programming
8.1
Programming Interface
The Model 7007 is programmed using a graphical interface through a smartphone, a laptop/tablet, or other browser-
capable device.
The subscriber is connected to a LAN through the J10 Ethernet connector. The default network protocol is DHCP. The
IP address obtained is shown in the app only during subscriber power-up. An example display is shown below. The
actual IP address will depend on the network the subscriber connects to.
Note:
If DHCP is not available, the IP address is set to 169.254.100.1.
8.2
Logging In
Connecting to the 7007 configuration page requires a login. Enter the IP address of the subscriber into a web browser,
then enter your username and password at the login screen. The default username and password are admin
(lowercase):
The following screen appears after a successful login:
Change Login Password
1.
Click the System tab as shown below:
2.
Place the cursor in the Current Password text box. Enter the current password.
In the New Password text box, type the new password. Type the new password again in the Confirm box
3.
and click Change Password.
23
Part No. 40-7007 Rev. 2B, 4/9/2022
Advertisement
Table of Contents
