Yamaha Arius YDP-105 Owner's Manual page 17

1.
Align the side boards with each end
of pedal box, and lightly tighten
with flat head screws (6 × 20 mm)
for temporary fastening
These screws will be tightened securely later in
step 3.
Side board (R)
× 4
Flat head screws (6 × 20 mm)
2.
Attach the back board.
Depending on the model, the surface color of one
side of the back board may be different from the
other side. In this case, position the back board so
that the side facing the front (pedal side) matches
the color of the main unit.
Side board (R)
Back
board
1
2
2 - 1
2 - 3
2-1
Place the back board on each foot of side
boards.
2-2
Attach the top of the back board by
temporarily fastening the thin screws (4 ×
12 mm).
2-3
While pushing on the lower part of the side
boards from the outside, secure the bottom
ends of the back board using tapping screws
(4 × 20 mm) in the order from outside to
inside ( → ).
1 2
Side board (L)
Pedal box
2 - 2, 2 - 4
Thin screws
× 2
(4 × 12 mm)
Side board (L)
2
1
× 4
Tapping screws (4 × 20 mm)
2-4
Securely tighten the screws on the top of the
back board that were attached in step 2-2.
3.
Secure the pedal box.
Securely tighten the screws on the pedal box that
were attached in step 1.
Side board (L)
Back board
Pedal box
3
4.
Set the main unit in place.
Main unit
At least
10 cm
Side board (R)
At least
10 cm
Back board
4-1
Be sure to hold the bottom surface at least
10 cm inside from the edge of the main unit
so that you do not pinch your hands.
4-2
Place the main unit on the side boards so
that the front of the main unit and the side
boards are aligned. Slide the main unit
forward and insert the metal fittings on the
bottom of the main unit into the metal
fittings on the side boards.
CAUTION
• Be careful not to pinch your hands or drop the main
unit.
• Do not hold anywhere other than the specified
position.
Keyboard Stand Assembly
Side board (R)
Side board (L)
17
YDP-105 Owner's Manual