2. Cold Water Supply: 1/4” (6.35mm) lever ball 5. Power: The system requires two dedicated CARB IN REQUIRED FOR A SUCCESSFUL IN- valve. 220V/13 amp circuits to run your Quatreau. CHILLED IN STALLATION. IF YOU DO NOT HAVE THIS PLEASE REQUEST IT FROM YOUR MAINS...
QT553 unit when it SmartTap™ other ends to the manifold outlet stems pro- is installed. truding from the top of the QT553 as follows: * If installing SmartTap™ model, please use the template to cut hole TouchTap™ INSTALLING QUATREAU TAP CONNECTING YOUR TAP...
As part of this installation, you will also install a The Quatreau chiller carbonator is sited next to separate cold water supply with a 1/2” (12.7mm) the QT553. Usually, this will be to the left of the isolation valve.
5. Refit the housing to the system and activate RE-SANITATION AND FILTER the water supply. CHANGE PROCEDURE Sanitation only needs to be done when they change the Carbon Filter. To sterilize the water heater and chiller system and change filter at service intervals, use the following procedure.