Quatreau SMARTTAP 553-B Installation Manual

Quatreau SMARTTAP 553-B Installation Manual

Advertisement

Quick Links

INSTALLATION MANUAL
BOILING
CHILLED
SPARKLING
220V/50Hz

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMARTTAP 553-B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Quatreau SMARTTAP 553-B

  • Page 1 INSTALLATION MANUAL BOILING CHILLED SPARKLING 220V/50Hz...
  • Page 2 CONTENTS QUATREAU SMART TAP INSTALLATION MANUAL TYPICAL INSTALLATION • QUATREAU SMARTTAP™ TYPICAL INSTALLATION • QUATREAU SMARTTAP™ PRE-INSTALLATION CHECKLIST • UNPACKING YOUR EQUIPMENT • INSTALLING QUATREAU SMARTTAP™ 3, 4 • INSTALLING AIRGAP DRAIN • INSTALLING VENTILATION - CHILLER UNIT • CONNECTING WATER SUPPLY 7, 8 •...
  • Page 3 4. Power: The system requires two (2) dedicat- b. Drill and bits suited to the work surface ed 220V/13 amp circuits to run your Quatreau. c. SmartTap™ 1 x 30mm core bit (or closest match) d. SmartTap™ with Drain 1x 150mm core bit (or closest match) * 30mm core bit for the buttons.
  • Page 4 2. Place the saddle valve in a position to allow proper gravity fall from the faucet through the air gap into the saddle valve. INSTALLING QUATREAU SMART TAP™ INSTALLING AIRGAP DRAIN...
  • Page 5 SECTION FOUR SECTION FIVE INSTALLING THE VENTILATION CONNECTING WATER SUPPLY FOR THE CHILLER UNIT 1. Connect your cold water supply using the 1/4” (6.35mm) blue tubing that is supplied in the kit. Ventilation will ensure your chiller performs to Connect it to the right side of the boiler. its specifications.
  • Page 6 You may need to add a pump to ensure tilation and air movement, without which the the optimum psi is supplied to the Quatreau system will not chill correctly. system. DO NOT TURN ON THE POWER TO THE 8.
  • Page 7 5. Refit the housing to the system and activate RE-SANITATION AND FILTER the water supply. CHANGE PROCEDURE Sanitation is required at an annual service, where the carbon filter is also changed. To ster- ilize the water heater and chiller system and change filter at service intervals, use the follow- ing procedure.
  • Page 8 11. Now refit the filter housing, carefully ensure the gasket is in place, and hand-tight the stain- less steel housing. Distributed by: Global Water Solutions Find out more at: www.Quatreau.com QST553/CS20 - 07262021 © gws July 2021 RE-SANITATION AND FILTER CHANGE...

This manual is also suitable for:

Cs20

Table of Contents