Reverse Function - Kenwood TH-G71E Instruction Manual

REVERSE FUNCTION

When used while monitoring a repeater, the Reverse
1
function allows you to manually check the signal strength
of a station accessing the repeater. If the station's signal
2
is strong, it is best to move to a simplex frequency to
continue the contact and free up the repeater.
3
Press [REV] to switch the Reverse function ON (or
OFF).
4
• The receive frequency and the transmit frequency are
exchanged.
5
"R" appears when the function is ON.
•
6
7
8
Note:
◆
If pressing [REV] places the transmit frequency outside the allowable
9
transmit frequency range, an error beep sounds when
pressed, and transmission is inhibited.
10 ◆
If reversal would place the receive frequency outside the receive
frequency range, an error beep sounds when
reversal occurs.
11
◆ Automatic Repeater Offset does not function while Reverse is ON.
◆
You cannot switch Reverse ON or OFF while transmitting.
12
13
14
15
16
is
[PTT]
[REV] is pressed. No