To Connect A Secondary Cd Player; To Connect A Secondary Tape Deck - Kenwood Sovereign VR-5080 Connection And Setup Manual

Chapter One : Connecting Your Devices
Connecting Your Secondary CD Player or Tape Deck, continued
Do not plug in the receiver to AC power until you have
connected all your devices.
This section focuses on the connections from your CD player
or tape deck to the VR-5700/VR-5090/VR-5080. Please re-
fer to your CD player or tape deck's instructions for more
detail about its connection jacks and capabilities.
Each set of instructions in this section shows one of several
possible variations on connecting your CD player or tape
deck. For further assistance on optional configurations, con-
tact the store where you purchased your CD player or tape
deck.
Do not connect a system control cable from any unit con-
nected via the CD2/TAPE2 MONITOR jacks.

To Connect a Secondary CD Player:

1. Connect the audio cables from the CD player's audio
jacks to the receiver's CD2/TAPE2 MONITOR PLAY IN
jack set as shown to the left.
Do not connect the system control cable from the sec-
ond CD player, even if it supports system control.
2. Go to "Noting Your Devices" on page 3 and note which
jacks you used to connect your CD player. In addition,
note the brand name and model number of the CD
player.
If you connect a second tape deck, you cannot connect a
second CD player.

To Connect a Secondary Tape Deck:

1. Connect the audio cable from the tape deck's Play OUT
jacks to the receiver's CD2/TAPE2 MONITOR PLAY IN
jacks.
2. Connect the audio cable from the tape deck's Rec IN
jacks to the receiver's CD2/TAPE2 MONITOR REC OUT
jacks.
Do not connect the system control cable from the sec-
ond tape deck, even if it supports system control.
3. Go to "Noting Your Devices" on page 3 and note which
jacks you used to connect your tape deck. In addition,
note the brand name and model number of the tape
deck.
If you connect a second CD player, you cannot connect a
second tape deck.
25