Loudness; System Q; Speaker Setting - Kenwood KRC-709 Instruction Manual

Loudness

This function amplifies low and high tones when the volume is
turned down.
The LOUD indicator lights up when the loudness function is
on.
Turning Loudness On/Off:
Press the LOUD button for at least one second to switch the
loudness on and off.

System Q

You can recall the best audio setting preset for different types
of the music.
Switching the Preset Sound Setting:
Each time you press the Q button, the preset sound setting
switches as follows:
Scan of Flat – Easy
(Default setting)
User memory*
Flat
Rock
As you proceed, each indicator would go on.
NOTE
The System Q function changes the values of the following
sound quality parameters:
Bass center frequency, bass level, bass quality factor, bass
extend, middle center frequency, middle level, middle quality
factor, treble center frequency, and treble level.
Their setting values are different depending on the setting of the
speaker setting mode.
Easy
Jazz
Pops
*User memory:
The unit returns to the state
Top 40
adjusted the last time with
the audio control setting feature.

Speaker Setting

This function allows you to adjust the setting that is recalled
with the System Q, according to types of speakers.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
2
Press the Q button to enter the speaker setting mode.
Press either the 4 or ¢ button to select the type of
3
speaker. The setting switches as follows.
Off ("SP OFF") / For 6/6x9 in. speaker ("SP 6*9/6inch") /
For 5/4 in. speaker ("SP 5/4inch") /
For the OEM speaker ("SP O.E.M.")
4
Press the Q button to end the speaker setting mode.
NOTE
Speaker setting function allows for tuning of bass, middle and
treble
— 7 —