Cassette Player Features Playing Cassette Tapes; Fast Forwarding And Rewinding Cassette Tapes; Using Dolby B Noise Reduction; Switching Tape Types - Kenwood KRC-708 Instruction Manual

Cassette player features
Playing Cassette Tapes
Loading and Playing Cassettes:
Press the ¡(EJECT) button to slide open the faceplate,
showing the cassette (insertion) slot. Holding the cassette with
the tape exposed to the right, insert in the slot.
The faceplate will close, and the tape will start playing.
The IN indicator lights up when a cassette has been loaded.
Playing Cassettes Already Loaded:
Press the SRC (source) button repeatedly to select the tape
mode. "TAPE" is displayed when the tape mode has been
selected.
The tape will start playing.
Listening to the other side:
Press the PROG button.
Tape play switches to the other side.
Eject:
Press the ¡(EJECT) button to stop tape play. The faceplate
will slide to eject the tape.
Press the ¡(EJECT) button to close the faceplate.
2CAUTION
When the faceplate has been slid open, it might interfere with
the shift lever or something else. If this happens, pay attention to
safety and move the shift lever or take an appropriate action,
then operate the unit.
NOTE
• The sound will be temporarily muted while the faceplate is
moving.
• The only buttons that will work during the eject state are the
¡(EJECT), SRC, and ATT buttons, as well as the volume
control button.
• Remove a cassette from the unit when not listening to it for a
while. If you leave it in the unit too long, the tape may stick to
the tape head and cause unit malfunction.

Fast Forwarding and Rewinding Cassette Tapes

Fast Forwarding Tapes:
Press the FM button.
Rewinding Tapes:
Press the AM button.
Canceling:
Press the PROG button.
Normal tape play will begin.

Using Dolby B Noise Reduction

Listen to tapes recorded using Dolby B NR.
Turning Dolby B Noise Reduction On/Off:
Press the B NR button to switch Dolby B NR on and off.
The B NR indicator lights up when it is turned on.

Switching Tape Types

Select type of tape being played.
Switching Tape Types:
Press the MTL (Metal) button to switch the metal tape
indicator on and off and to select the tape type.
Turn the MTL indicator off for normal tape (Type I) playback.
Turn the MTL indicator on for the following tape types:
CrO (Type II) FeCr (Type III) Metal (Type IV)
2
Selecting the wrong tape type may cause sound quality to
suffer.

Using Direct Program Search System (DPSS)

Skip forward or backward to other tracks during playback.
— 20 —