Handling Of Samples And Reagents; Safety Instructions - Maintenance And Repair; Behavior During Emergencies - Endress+Hauser analytikjena SPECORD PLUS Operating Manual

SPECORD PLUS
3.4.3

Handling of samples and reagents

3.5 Safety instructions – maintenance and repair
3.6

Behavior during emergencies

The device, the accessories and the PC may only be connected to the mains net-
¡
work when the device is switched off.
¡ Electrical connection cables between the device and the system components may
only be connected or disconnected when the device is switched off.
Before opening the device, the device must be switched off via the main switch
¡
and the power plug must be disconnected from the power outlet!
Work on the electronics may only be carried out by the customer service of Ana-
¡
lytik Jena and specially authorized technicians.
The operator is responsible for the selection of substances used in the process, as
¡
well as for their safe handling. This is particularly important for radioactive, in-
fectious, poisonous, corrosive, combustible, explosive and otherwise dangerous
substances.
The operator is responsible for carrying out suitable decontamination should the
¡
device be contaminated with dangerous substances on the outside or in the sam-
ple chamber.
¡ Splashes, drops or larger reagent spills must be removed and cleaned using an
absorbent material such as laboratory wipes or paper towels.
Maintenance of the SPECORD PLUS is always carried out by the customer service
¡
department of Analytik Jena or its authorized and trained personnel.
The user may only perform the maintenance tasks described in this operating
¡
manual (→ "Care and maintenance"  31).
¡ The exterior of the SPECORD PLUS may only be cleaned with a damp, not drip-
ping, cloth after the device has been switched off.
Always only carry out any maintenance and repair work on the device when it is
¡
switched off (unless otherwise indicated).
A risk of burns from hot lamps and surfaces is present. Only carry out mainte-
¡
nance tasks and the replacement of system components (e.g., lamps) after a suf-
ficiently long cooling phase.
¡ If necessary, remove the protective cap from the VIS lamp after insertion. A risk
of fire is present!
Use only original spare parts, wear parts and consumables. They have been
¡
tested and ensure safe operation. Glass part are wear parts and are not subject
to the warranty.
If there is no immediate risk of injury and if this is possible, immediately switch the
device switch of the SPECORD PLUS and the connected system components (PC, ac-
cessories) to the "0" position during dangerous situations or in case of accidents and
disconnect the mains plugs from the mains outlets!
Note: For the PC, there is a risk of data loss and damage to the operating system!
Security
9